201-450 LPIC-2 Exam 201 v4.5 Practice Questions
Prepare for 201-450 with more than an answer.
- Exam fee
- $200 USD
- Level
- Professional
- Valid for
- 5 years
Domains covered on the exam 7
- Capacity Planning13.1%
- Linux Kernel14.8%
- System Startup14.8%
- Filesystem and Devices14.8%
- Advanced Storage Device Administration13.1%
- Networking Configuration18%
- System Maintenance9.8%
- 1
After installation of a self-compiled kernel, modules that need to be loaded cannot be found. What make target was likely missed while installing the kernel? (Specify ONLY the make target without any command or parameters.)
Show answer details
Correct answer: B
B
- 2
Which of the following commands lists IPv4 addresses and MAC addresses of network nodes that the local system has seen on its directly connected IP networks?
Show answer details
Correct answer: D
D
- 3
Which single command simulates a failed device within a RAID 5 array?
Show answer details
Correct answer: B
B
- 4
Which of the following commands by default provides the PIDs of the processes sorted by which are using the most CPU cycles on the Linux system?
Show answer details
Correct answer: B
B
- 5
A system administrator needs to connect two separate physical networks (192.168.1.0/24 on
eth0and 192.168.2.0/24 oneth1) at Layer 2, allowing devices on both networks to communicate as if they were on the same broadcast domain. Which of the following technologies should be implemented on the Linux system?graph TD subgraph Network1 ["192.168.1.0/24"] A[PC A] B[PC B] end subgraph Network2 ["192.168.2.0/24"] C[PC C] D[PC D] end subgraph LinuxBox E[eth0] F[eth1] end A --- E C --- F E -- "Connects L2" -- FShow answer details
Correct answer: C
A software bridge in Linux connects multiple network interfaces at Layer 2, creating a virtual switch. This allows devices connected to the bridged interfaces (
eth0andeth1) to exist on the same broadcast domain and communicate directly, fulfilling the requirement. - 6
Which of the following commands restores only those files containing Ipi in their name from the archive lpifiles.tar.gz?
Show answer details
Correct answer: D
D
- 7
What command will remove a physical volume from a volume group? (The options contain ONLY the command without the path or parameter.)
Show answer details
Correct answer: A
A
- 8
How is the source code for the main Linux kernel modules distributed?
Show answer details
Correct answer: D
D
- 9
Which is the main configuration file for the SystemV init process? (Specify the full name of the file, including path)
Show answer details
Correct answer: B
B
- 10
Which of the following commands creates a Btrfs subvolume named volume in/mnt?
Show answer details
Correct answer: A
A
