3V0-42.20 Advanced Design VMware NSX-T Data Center Practice Questions

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:Migrating existing data center to KVM hosts.

Redundancy and high availability are required.

No component can be a single point of failure.

Which selection should the architect recommend? (Choose the best answer.)

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:

There are applications which use IPv6 addressing.

Network administrators are not familiar with NSX-T Data Center solutions.

Hosts can only be configured with two physical NICs.

There is an existing management cluster to deploy the NSX-T components.

Dynamic routing should be configured between the physical and virtual network.

There is a storage array available to deploy NSX-T components.

Which risk was documented by the architect? (Choose the best answer.)

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop about ESXi Host networking:A total of 50 ESXi hosts to be configured as Transport Nodes.

All ESXi hosts have a dedicated 2 x Intel lOGbps Physical Network adapter for the Overlay Traffic.

To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)

Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

A design for a large-scale NSX-T deployment includes multiple vCenter servers. Which NSX-T construct is used to define the scope of hosts and clusters that a single NSX-T installation can manage and prepare as transport nodes?

Which is a family of solutions for data center designs that span compute, storage, networking, and management, serving as a blueprint for a customer’s Software Defined Data Center (SDDC) implementations? (Choose the best answer.)

Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:

Some workloads should be moved to a Cloud Provider.

Extend network’s VLAN or VNI across sites on the same broadcast domain.

Enable VM mobility use cases such as migration and disaster recovery without IP address changes.

Support 1500 byte MTU between sites.

Which selection should the architect include in their design? (Choose the best answer.)

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during a workshop:

There are six hosts and hardware has already been purchased.
Customer is planning a collapsed Management/Edge/Compute cluster.
Each host has two 10Gb NICs connected to a pair of switches.
There should be no single point of failure in any proposed design.

Which virtual switch design should the architect recommend to the organization? (Choose the best answer.)

What selection is the key design benefit provided by a dedicated Edge Cluster VM or Bare Metal? (Choose the best answer.)